For any Hyundai drivers reading who have a tire pressure light illuminated on their dashboards, we see you. This can be difficult to understand and remedy if you aren't familiar with how to fix it, which is why we've written this post. Your Hyundai tire pressure light is in place to alert you when something is not right with one or many of your tires. In this article, we will dive deeper into why this light turns on and how you, as a Hyundai owner, can get it to turn off. Keep reading!
Hyundai Tire Pressure Monitoring System
The Hyundai Tire Pressure Monitoring System, or TPMS for short, is the technology that most Hyundai's will have that is responsible for monitoring and alerting drivers of low pressure on any one of four tires on the vehicle. You may see this light flash on following a snap change in weather, after a long road trip, post-accident, pothole, curb, or tire damage, or as a warning for slightly lower tire pressure than usual.
Of course, you should periodically check your tire status through your vehicle's touchscreen display to ensure all of its tires are filled enough and have plenty of pressure.
Does TPMS Fail?
Although it is less likely for your Hyundai Tire Pressure Monitoring System to fail outright, that's not to say this can't happen. Usually, drivers see their TPMS fail due to the following factors:
- Mechanical or electrical failure
- Broken accelerometer
- Low TPMS battery power
- Blocked pressure port
If you suspect your tires are fine but your TPMS is the problem instead, the experts at Colonial Hyundai's Service Center will be here to step in. We handle bumper-to-bumper coverage and are happy to inspect your new or used model.
Tire Pressure Change with Weather
One of the more common causes for a Hyundai tire pressure light on the dash is a change in weather. This could be a snap cold front, an unusually warm weekend, or because of parking outside during a storm. Most drivers try to keep their car out of the elements as much as possible, although this isn't a luxury we all have. If you notice your tire pressure light flashing following a rapid change in weather, this is entirely normal. You may still need to add more air to them, though.
What to Do If Your Tire Pressure Light Is On
If your Hyundai tire pressure light turns on and stays on, this is when you want to add air to your tire or let some out, depending on the reading. Hyundai models often need to be at or around 33 PSI, so that is a baseline figure for owners. You can always swing by your local Hyundai dealership or service center for tire inflations and checks, so we welcome all customers throughout the year. Remember, Colonial Hyundai in New London, CT, is a full-service dealer and repair location that provides comprehensive tire and TPMS solutions.Â
Â
Resetting Your Hyundai Tire Pressure Light
Regarding a reset for your Hyundai tire pressure light, there are a couple of ways to do this. One method is to drive at or slightly above 50 MPH for ten minutes, which can cause your sensor to reset the next time you turn on the car. The next way is to keep your vehicle off while turning the key to the "On" position. You want to hold the TPMS reset button until the tire pressure light blinks three times, then release it. Wait ~20 minutes, and the issue should stop. Your third option is to fill every tire to 3 PSI over their recommended amount, then deflate them completely. You will then fill them to their factory-recommended PSI.
Both methods should get this system back to reading your tire pressure as intended.
If this does not work, you may need a new TPMS altogether.
What to Do If the Tire Pressure Light Doesn't Reset
If after you try resetting your TPMS to no avail, there could be something wrong with the tires on your Hyundai. Remember, this system is meant to read and alert drivers when there is low or too high tire pressure across your model's four wheels. If the PSI exceeds ~33/the recommended level, your light will stay on until this is fixed. That is its job.
Importance of Addressing the Issue Promptly
One reason we find it important to address your Hyundai tire pressure light quickly is that your tires are the first and only point of contact your car, truck, or SUV has with the road below. If there is not enough pressure in your tire(s), you can fall out of proper wheel alignment, ultimately running into more expensive and serious repairs. The same goes for an over-filled tire. If there is too much pressure, you risk a pop while driving.
Your tires need routine inspection and upkeep, both of which Colonial Hyundai in New London will happily assist you with.
Tips for Maintaining Proper Tire Pressure
For Hyundai owners wanting to stay on the road and out of the shop for longer, there are many ways to maintain proper tire pressure throughout the year. We recommend the following methods:
- Regularly check your tire pressure
- Fill tires to the recommended PSI
- Remove, adjust, and re-apply valve caps
- Use a high-quality pressure gauge
- Inflate your tires as needed
- Avoid overfilling your tires
- Balance your tires periodically
- Schedule routine tire rotations
Why Choose Colonial Hyundai for Tire Service
Anytime someone with a Hyundai needs tire service in New London, CT, they call Colonial Hyundai. We offer a team of automotive care experts and a state-of-the-art service center for our drivers to rely on for tire-related issues. We stand by our quality, training, and technicians and welcome big and small repairs into the shop.
Â
Schedule Service at Colonial Hyundai
Now that you better understand how your Hyundai tire pressure light operates, it might be time to swing by Colonial Hyundai in New London, CT. We are skilled in addressing, repairing, and maintaining our results throughout the year and will be happy to fill your tires during regular business hours. Come see us between Monday and Friday each week!
